Dana Keypad

PRODUCT OVERVIEW

The Danapad V3 Keypad allows you to operate your Danalock V3 Smart lock without a smartphone. Just use a personal PIN code to unlock your home.
Never worry about anyone losing a key again! With a Bluetooth interface to the Danalock, the Danapad extends secure, controlled access in your home.

CONTENTS

After you unbox your Danapad, you will see:

• Wall Mounting Plate

• 2 Screws

• 2 Wall plugs

• Wireless Pin Keypad Danapad

SPECIFICATIONS

• Pin code length is 4 – 10 digits

• Power: 4 AAA batteries

• Pin Code Memory: Up to 20 different pin codes

REQUIREMENT

• Cross screwdriver

• Four (4) AAA batteries

• Smartphone with internet (must belong to the homeowner)

INSTALLATION

STEP 1

Remove the cover by lifting the backside of the Danapad to expose the battery holes.

STEP 2

Now insert 4 × AAA batteries into the battery hole.

Note: If the batteries are correctly installed, the PIN keypad should light up.

STEP 3

Replace the battery cover on the backside of the Danapad.

STEP 4

Using a pencil, mark the drill holes by placing the backplate on the installation location. This will enable you to know where to drill. See dimensions for appropriate placement below:

 0.3m- from the door AND 1.5m from the floor

STEP 5

Remove the plastic backplate of the Danapad and drill the holes in the marked points. It must be 1.5 metres from the floor.

STEP 6

Insert the wall plugs into the drilled holes.

STEP 7

Attach the back placing it on the wall and screwing with the supplied screws. Make sure the screws are tight enough.

STEP 8

Now install the Danapad by mounting it on the back plate. Carefully attach it at an angle and twist clockwise to its upright position. You should hear a clicking sound from the Danapad, indicating that it is properly installed and has reached the final position.

DISMOUNTING

To dismount the Danapad, simply press into a hole at the top of the case with a paperclip and turn it counter clockwise.